PSP Protective Filter

Many people have problem applying the filter. If you just peel off and apply the sticker directly, you will face the following 3 major problem:

1. Dust particles
2. air bubbles (or known as air pockets)
3. Sticker orientation accuracy

To solve the above problems, here is the secret and the correct steps, not limited to this PSP filter, in fact, this secret applied to all stickers application.

Do the following steps, and you will be amazed with the result.

1. Wipe the screen clean
2. Spray diluted body shampoo (lotion, detergent, etc.. anything alcaline based will do, just add water to make it diluted) on both the screen and the sticky side of the filter (I said SPRAY! Spray-job is more even than hand-job, hand-job still works but risk of finger prints and your hand has to be applied as well, and rather a bit messy)
3. Apply the filter (while it is still wet on both screen and sticker)
4. Adjust the filter to the correct position desired.
5. Push the liquid out with a credit card from middle to outside (at the same time, dust particles come out together with the water) until it is completely dry.

You then have a perfect application of filter and air bubble-less.

This is the same technique as applying tinted film/stickers on glass windows, car windows and wind screen by the car assessories professionals.

Try it, you will be amazed by the result. Don't blame the sticker for air pocket, you only need to know the right technique, that's all.

This product works well if applied right. Follow the instructions; all instructions, for best results. I had no air bubbles, protects really good, easy to clean. Only thing I have a PSP thin and the filter dosent cover the entire screen, there is a little left over on the edges, not very noticeable though. Only thing I dislike, it only comes with one filter.

I don't know how this item got so many good reviews. I own a pink import model PSP, the original 'fat' version. And yet people who own the thin one are also saying that this product didn't work at all for them. I'm wondering who it DID work for. The filter was too small for the screen, and completely covered it in air bubbles.

One of the reviewers here mentioned that air bubbles are from you putting the wrong sheet on it -- it's not. I used the correct filter, the one between the two sheets, and it was covered in dust particles and little hairs instantly, pretty much everything that is floating in the air. Then when I laid it down, it was full of air bubbles no matter how many times I cleaned it or reapplied it.

Don't buy this. Get a case instead, and buy yourself some Displex scratch remover to keep the screen looking brand new. This kind of thing does nothing.

The size is fine for the PSP slim. There's maybe 1/64" border that it doesn't protect, which allows air bubbles to be worked out. It's just like applying any appliqué to glass, it takes patience and a couple of tries to get it perfect. The only complaints are that it does little to nothing to reduce glare, and it's not rigid like I expected, so sharp pokes can still damage the screen.

Nice filter, it protects your psp screen from scratches, dust, etc. I recomend it for everyone who has a psp.